Whirlpool Washer Lid Switch 3949238

CUSTOMER REVIEW



I have a Kenmore washer model # 110.24622300. This Whirlpool lid switch worked perfectly on my Kenmore. I'm doing a much needed load of laundry right now! So that's it as far as my review. It fit and works perfectly. I'm very satisfied.



Hopefully someone else gets some value out of this next piece. I found these instructions for removing the back panel with those clips. I wish I had these when I was taking the back panel off. Regardless, they were invaluable when trying to put the back panel back on.



************************

step 1 - remove control panel by removing the end caps of the back guard. grab the top of end caps at the top in the back and pull forward (I put a screwdriver in there to help pry it up.) They will un-clip. Then remove the two screws found behind caps at the bottom. grab the control panel on both side and swing bottom towards you while pulling up. it will fold over the top of back panel.



step 2 - remove the cabinet by removing the gold colored clips on each side. use a screw driver to pry the front of the clip forward and up. unplug the lid switch in the top. one clip three wires. open the lid and tilt cabinet forward to about a 45 degree angle and slide away from machine.

*************************



The lesson I learned from all this is that you should never just let the lid of your washer drop shut. I didn't know why I shouldn't be doing that previously although now that I think about it it's obvious. NOW I know!



Kevin



via Amazon Best Seller V2 copy copy http://ift.tt/RAZpVI